Sized channels
2 to 14 mm diameter: USB, laptop charger, HDMI, headphones.
Cable organizer to 3D print
Generate a desk cable clip with 1 to 10 channels sized to your cable, which snap in. With double-sided tape or screws. Free and online.
- Free
- No sign-up
- STL and 3MF
- Millimeter precise
- Runs in the browser
About the cable organizer generator
Charging cables always fall behind the desk. This organizer has channels the exact diameter of the cable with a slightly narrower opening: the cable clicks in and stays put, but comes out when you pull it.
Choose how many channels, the cable diameter and the block length. Stick it to the edge of the desk with double-sided tape or screw it through the side tabs.
What you can adjust
Snap-in
The opening is 72% of the diameter, with a V lead-in.
1 to 10 channels
Separated by walls so one cable cannot slip into another.
Tape or screws
Flat base for tape, or tabs with countersunk M3 holes.
Ideas for use
- Chargers on the desk edge
- Cables behind the monitor
- Nightstand
- Electronics workbench
- Car dashboard
How it works
- Measure the cable diameter (with calipers or a ruler) and choose how many channels.
- Click "Create in the editor": the organizer opens ready.
- Print as is, without supports, and stick or screw it to the desk.
How to print
- Material
- PETG (flexes better) or PLA
- Layer height
- 0.2 mm
- Infill
- 20%
- Supports
- Not needed
- If the cable is too hard to push in, increase the diameter by 0.5 mm.
- Cables of different sizes? Make one organizer for each, or change a channel in the editor.
FAQ
The cable does not stay in. What now?
Decrease the diameter by 0.3 to 0.5 mm: the opening follows and the fit gets tighter.
Does it work with thick laptop cables?
Yes, up to 14 mm in diameter.
Is it free?
Yes. The maker and the editor are free and run in your browser. Without an account, the project is kept for 48 hours; with a free account, it is kept in your account.
Which format do I download?
3MF (recommended: keeps colors and opens directly in Bambu Studio, OrcaSlicer and Creality Print), STL or OBJ, always in millimeters.
Create your cable organizer now ↑
More generators
Box with lid to 3D print
Exact inner size, fitted or sliding lid and dividers.
Gridfinity bins to 3D print
Standard 42 mm base, dividers and magnet holes.
Drawer organizer to 3D print
Trays that fill the whole drawer, made to its size.
Drawer and shelf label to 3D print
Raised two-color text, with tape, screws or magnets.
Wall hook to 3D print
J hook printed on its side: strong, with countersunk holes.
Battery holder to 3D print
AA, AAA, 18650, CR2032 or 9V, in columns and rows.
Wall tool holder to 3D print
Shelf with holes or slots for screwdrivers and pliers.
Toothbrush holder to 3D print
Cup with a holed insert that keeps each brush apart.